New Bug/error Or New Changes To Editor ?

just went to republish a map after a few tweaks , everything as usual get the dos box running and noticed error "failed to load (map name) " everything goes through the usual steps wait for ages then get failed to publish , tried again same failed to publish , so i fully loaded the editor then re tried to publish and successfully published ,
ive never had to fully load editor before to do a publish , is this new changes ? or just a bug / error ?
ive never had to fully load editor before to do a publish , is this new changes ? or just a bug / error ?
Comments
Are you sure it wasn't just a coincidence on the fix?
This has been a test of the emergency flame-fest system. Please do not adjust your set.
muzza was your editor fully loaded ?
1st had been published post patch ,that republished without fully loading the editor
2nd was published pre patch ,and failed to publish until i fully loaded the editor ,then published ok
This has been a test of the emergency flame-fest system. Please do not adjust your set.